Should I overlap drip edge?
Nail high up on the drip edge so that the shingles will cover the nails. Ideally, you’d nail about every 12 inches, and in no circumstances should you have 16 inches or more between nails. When you place the next drip edge piece, it should overlap the first by an inch.
Does drip edge go over shingles?
Drip edge can be installed after shingles have been put on. Simply lift up the lower ends of the shingles to place the drip edge. But make sure to put the drip edge underneath the felt underlayment along the eaves so water cannot get below the drip edge.
How far should shingles overlap gutters?
1/4 to 3/8 inch
Most shingle manufacturers recommend a 1/4 to 3/8 inch overhang over your eave, which is where your roof ends by your gutter. In many cases, and particularly as the home ages and settles, the roof edge at the eave edge can wave in and out by more than this amount.
How far should you overlap drip edge?
Adjacent drip edge pieces should be lapped minimum 2 inches. Asphalt shingles should overhang the exterior edge of the drip edge by ¼ to ¾-inch.
Should drip edge be tight to fascia?
A vertical drip edge lip extends down roughly 1 5/8″ and as Steve points out, should not be set tight against the fascia board or water may run behind the gutter and down the fascia, inviting leaks and rot.
How far should shingles overhang drip edge?
The edge of the shingles should hang over a roof between an inch and an inch and a half — or between a half inch and three-quarters of an inch if drip edge flashing is installed. Too much overhang and the shingles could blow off in high winds; too little can allow water to seep into rake or fascia boards.
How close should gutters be to drip edge?
How Far Should Gutters Be From the Roof Edge? The gutter should be installed as close to the shingles as possible; no more than 2 or 3 inches. If the gutter distance is more than 3 inches, the rain will run off the roof and won’t drain properly.
Do gutters go under drip edge?
It is recommended that gutters are placed under or ‘behind’ the drip edge of your roof. A drip edge refers to a component that hangs over the roof and has an outward projecting lower edge.
How far should shingles hang over drip edge?
Shingles should be installed over the drip edge a minimum of 3/8” (9 mm) at both the eave edge and the rake edge. If the drip edge extends… out from the rakes and eaves (typically called DL Style or D Type), the shingles may be installed flush with the drip edge.
How much should shingles overlap drip edge?
How far should shingles extend past drip edge?
3/4”
Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.