Trending

How do I enable ip routing on HP ProCurve switch?

How do I enable ip routing on HP ProCurve switch?

HP Procurve 2910 Switch (routing configuration)

  1. login to the switch through TELNET OR SSH.
  2. Standard configuration does not contain a password.
  3. type configure terminal.
  4. type a hostname “name of the switch”.
  5. Type vlan 1 and configure an ip address.
  6. Enter a default gateway.

How do I enable Web interface on HP switch?

To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …

How do I enable ip routing on Aruba switch?

Hi! to let the Aruba 2930F to enable its IPv4 Routing features you just need to execute the ip routing CLI Command in config mode (then write memory). Doing that your two defined VLANs will be routed each others (by means of the Aruba 2930F -> the static route you set will be then, and actually is, erroneous).

How do I configure my HP network switch?

Installing the switch

  1. Verify components shipped with the ProCurve 2520 Switch.
  2. Prepare the installation site.
  3. Verify that the switch passes self-test.
  4. Mount the switch and route the power cords.
  5. Connect power to the switch.
  6. Connect the network cables.
  7. (Optional) Install mini-GBICs.

How do I enable IP routing on my router?

To enable IP routing, use the ip routing command in switch configuration mode. To disable IP routing, use the no form of this command. This command has no arguments or keywords.

How do I set up HP ProCurve?

How to: Configure a HP ProCurve switch

  1. Step 1: Connect your serial connection.
  2. Step 2: Conenct PuTTY.
  3. Step 3: Get the IP address.
  4. Step 4: Set time server.
  5. Step 5: Set SNMP community info.
  6. Step 6: Launch the web GUI.
  7. Step 7: Configure basic info.
  8. Step 8: Create VLANs.

How do I enable SSH on HP ProCurve switch?

How to: Configure SSH on HP ProCurve Switches

  1. Step 1: Log into the Switch. Log into the switch’s Web interface using an account with read-write permissions.
  2. Step 2: Create a Certificate.
  3. Step 3: Generate a Private/Public Key pair.
  4. Step 4: Enable SSH.

What happens if IP routing is not enabled?

Routing is often disabled by default in Windows NT. Use caution with the registry editor when enabling IP routing. If the set up is done incorrectly, it can cause issues with your entire system and might even require a complete reinstall of Windows NT or your other operating system.