Is there a reset button on a GE washing machine?
There is not an actual reset button on a GE washing machine. However, pushing the ‘Cancel’ button will clear any error message between the control board and the cycle control switch. Pressing the ‘Pause’ or ‘Stop’ button will then reset the cycle function.
How do I reset my General Electric Deep Fill washing machine?
Motor Reset Procedure:
- Unplug the washer for 1 minute from the electrical outlet.
- Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
- The motor has now been reset and is ready for you to start a cycle.
How do I troubleshoot my GE top load washer?
How to Troubleshoot a GE Top Load Washer
- Check the amount of detergent you have put in the washer.
- Examine the GE top load washer’s drain hose for leaks.
- Check the water connections to your GE top load washer.
- Check whether the GE top load washer lid is closing firmly.
- Check the load in your GE top loading washer.
How do you put a GE washer in service mode?
Follow these steps to enter the service mode on a GE front load washer.
- Close the door.
- Clear current cycles by pressing the power button.
- Disconnect power to washer for at least 30 seconds.
- Reconnect the power and within 30 seconds of reconnecting power complete the next step.
Why won’t my GE washing machine drain and spin?
A kink or clog in your washing machine’s drain hose could be interfering with water flow and preventing your machine from draining properly. To inspect the drain hose, turn off the power to the washer, disconnect the hose (have a bucket ready to catch any water), and check the hose for damage or obstructions.
Why won’t my GE washer fill?
If your washer won’t fill, check the hot and cold faucets to make sure they’re both turned on fully. GE washers require water pressure between 10 and 120 pounds per square inch. Check the fill hoses, which connect to the upper back left of most GE washers, and make sure the line has no kinks.
Why is my GE top load washer not spinning?
A loss of electrical power to the washer will cause a failure to spin. To check for power at the outlet, carefully plug a small table lamp or hair dryer into the wall outlet and turn it on. If it does not work, you may have blown a fuse, tripped a circuit breaker or have a defective wall outlet.