What is meant by sheet pile?
: any of various thick boards or planks that are wedge-shaped at the lower end and sometimes tongued on one edge and grooved on the other and are driven into the ground close together between gauged piles to form walls (as of a cofferdam) also : a rolled steel member used for the same purpose and so designed that each …
What is steel piling?
Steel sheet piles are long structural sections with a vertical interlocking system that create a continuous wall. The walls are often used to retain either soil or water. The ability of a sheet pile section to perform is dependent upon its geometry and the soils it is driven into.
What is sheet pile cofferdams?
Sheet pile cofferdams are a specific form of a temporary works solution and as such is a cornerstone to the range of services offered by Sheet Piling (UK) Ltd. The main purpose of a cofferdam is to exclude soil and/or water to form a safely supported excavation where construction works can progress.
What is piling sheet used for?
Introduction. Sheet Piling is used to provide temporary and permanent walls in the construction industry. Sheet piling is used as excavation support and for soil retention. It creates a border which keeps the soil back, away from the structure.
Why sheet piling is done?
Sheet pile walls have been used to support excavations for below-grade parking structures, basements, pump houses, and foundations, to construct cofferdams, and to construct seawalls and bulkheads. Permanent steel sheet piles are designed to provide a long service life.
How thick are sheet piles?
These piles are precast sheets 6 to 12 inches deep, 30 to 48 inches wide, and provided with tongue-and-groove or grouted joints. The grouted-type joint is cleaned and grouted after driving to provide a reasonably watertight wall.
What is bulkhead sheet pile?
ANCHORED SHEET PILE WALL OR BULKHEAD:- which is held above its driven depth by one or more tie rods or anchors at or near its top. CLASSIFICATION ACCORDING TO THE STUCTURAL TYPE AND LOADING SCHEME:- CANTILEVER SHEET PILE IN GRANULAR SOILS:- The wall rotates about the point O.
How is sheet piling measured?
The department will obtain the measured quantity by multiplying the length of the wall the plans show by the length of sheeting required. completed. The department will measure the area of the wall from the sheet pile tip elevation to the top cutoff.
What are the advantages of steel sheet piling?
10 Advantages to Sheet Piles: Sheet piles are recyclable and reusable. Piles can come in a wide range of lengths, size, and steel options. They can be used for temporary and permanent structures. They can be installed using silent and vibration-free methods.